Search
Now showing items 21-30 of 46
Anisotropic Fatigue Modeling Of Wrought Magnesium Alloys
(CSME-SCGM, 2018-05)
The merit of Jahed-Varvani (JV) as an energy-based model and Smith-Watson-Toper (SWT) as a critical plane fatigue model are assessed for three wrought magnesium alloys. The raw data, including the stabilized strain-stress ...
Shaker Vibration Test Of Epoxy Composites Reinforced With Pristine And Functionalized Carbon Nanotubes
(CSME-SCGM, 2018-05)
The vibration and damping characteristics of epoxy composites reinforced with pristine and functionalized multi-walled carbon nanotubes (MWCNTs) were investigated experimentally with potential use as integral passive damping ...
Glass micro-cutting by Spark Assisted Chemical Engraving
(CSME-SCGM, 2018-05)
Glass remains a difficult to machine material. Its brittleness, chemical resistance and relatively high thermal conductivity challenges available technologies. An interesting approach is to the use of hybrid technologies ...
A Study Of The Thermal And Mechanical Properties Of Recycled Crosslinked Hdpe
(CSME-SCGM, 2018-05)
Crosslinked high-density polyethylene (XHDPE) is used to manufacture large and rigid products, such as fuel tanks, using a rotomolding process. Currently, defective and post-consumer parts are not recycled and sent to ...
Buckling And Post Buckling Behavior For Unsymmetrical Laminates Part II: Stability Characteristics
(CSME-SCGM, 2018-05)
This is the second of two companion papers that examine the elastic buckling and post buckling behavior of unsymmetric cross-ply laminates. The existence of geometric imperfection and thermal mismatch between plies result ...
Analysis Of Thermal Losses In Air-Water Interfacial Solar Heating Systems
(CSME-SCGM, 2018-05)
This paper reports a numerical analysis of solar-driven seawater desalination systems with two configurations: a floating photo-thermal film at the air-water interface with and without an insulation layer located beneath ...
Simulating Layup Defects During Tow Steering In Automated Fiber Placement
(CSME-SCGM, 2018-05)
Automated Fiber Placement (AFP) offers valuable advantages which make this technology a suitable candidate for producing high-quality parts in the aerospace industry. However, there are limitations: number of defects may ...
Buckling And Post Buckling Behavior For Unsymmetrical Laminates Part I: Curing Cycle
(CSME-SCGM, 2018-05)
This is the first of two companion papers that examine the elastic buckling and post-buckling behavior of thin unsymmetric cross-ply laminates. When cured in a flat mold these panels possess two cylindrical equilibrium ...
Design, Fabrication, And Calibration Of A Mems Based Sensing Rosette For Quantifying The Influence Of Strain Engineering On The Piezoresistive Coefficients
(CSME-SCGM, 2018-05)
Strain has been used extensively in enhancing the electron mobility for high speed and low power transistors. As stretching the silicon atoms away beyond their normal atomic space has a significant influence on the carrier ...
A Novel Finite Strain Visco-Hyperelasticity Based Constitutive Model For Elastomers
(CSME-SCGM, 2018-05)
A novel three-dimensional finite strain viscohyperelastic constitutive model is proposed to capture the strain rate dependency of rubber-like materials. The overall material behavior is defined by cumulative description ...